MOTO GUZZI Stelvio 1200 4V, Service Station Manual

Page: 95 / 135

•
Use the sealing ring fitting tool on the flywheel-side flange to fit the sealing ring on the flange.
Specific tooling
19.92.71.00 Tool to fit the sealing ring on the flywheel-side flange
•
Fit a new gasket between the crankcase and the crankshaft flange, flywheel side.
•
Fit the crankshaft on the crankcase,
flywheel side.
•
Mark the crankshaft on the flywheel
side with the crankpin facing upwards.
•
Place the suitable sealing ring centring
tool on the crankshaft.
Specific tooling
12.91.20.00 Tool to fit the flywheel-side flange
together with sealing ring on the crankshaft
•
Place the flywheel-side flange on the
crankshaft and check if the dowel pin
with the O-ring is correctly placed.
•
When fitting the flange on the crank-
case, make sure that the three dowel
pins match the seats on the crankcase.
•
Apply Teflon tape on the two lower fix-
ing screws at the back in order to pre-
vent oil leaks.
•
Screw the eight flange screws on the
flywheel side proceeding diagonally.
•
Remove the sealing ring centring tool from the crankshaft.
Specific tooling
12.91.20.00 Tool to fit the flywheel-side flange together with sealing ring on the crankshaft
STELVIO 4V - 1200
Engine
ENG - 69