AGITO
28
www.Motion-Impossible.com
Motion Impossible Ltd.
AGITO Owners’ Manual v1.3 Firmware r4.13
28
+44 1454 501010
TOWER: INSERTING & REMOVING TOWER GAS-STRUT
Remove AGITO Tower from Case.
Attach battery and carefully invert the Tower (Red light indicates power).
Remove the dust cover and insert your chosen Gas-Strut, see Chart below.
Using the manual adjustment buttons, carefully fully extend the tower.
Ensure that the Gas-Strut remains aligned
When the Green Light Illuminates the Tower is fully extended
Rotate the Keyway by 45 degrees to lock the Gas-strut into place
Using the manual adjustment buttons, carefully fully contract the tower,
now replace the dust cover.
The Tower is now ready to mount to the AGITO.
To remove Gas-Strut reverse this process
Gas Strut Payload Chart
BLUE
7-13Kg
GOLD
12-18Kg
RED
17-23Kg
TOWER: ATTACHING TOWER TO AGITO
Attach the two side plates to the CORE
Inset and tighten the four 3/8
th
inch bolts
Place the Tower on to the side plates
Inset and tighten the four bolts
Finally attach
AGITO Core Aux Port 2 to Tower Control Port Cable (4-pin Lemo),
and attach Battery.
Ensure that the correct Gas-Strut is used for your Payload.
Do not run the Tower without a payload, as this may damage the internal mechanism.
Remove Gas-Strut when storing the Tower, to avoid damage.
