Moore 535 PROFILER, User Manual

Page: 91 / 151

82
Chapter 7 535-PROF User's Manual
Applications
The decimal point is defined by the DECIMAL parameter.
7. The next parameter is RAMP TM:## (## = 1 to 12). It defines the time for
the current ramp segment (##) to reach the current soak setpoint (##). This
parameter will only appear if
RAMP UNIT = TIME. Choices are:
D OFF ends recipe programming
R 00:01 to 99:59 HR:MN if TIME BASE = HOURS:MIN
R 00:01 to 99:59 MN:SC if TIME BASE = MIN:SEC
IMPORTANT: For each RAMP segment, you will scroll through and set
values for the next six parameters. However, choosing OFF for either RAMP
RT.## or RAMP TM## will conclude the programming.
8. The next parameter is RAMP EV:## (## = 1 to 12). It selects which events
will be activated during the current ramp segment. Choices are:
D NONE
• EVENT 1 event output 1 is selected
• EVENT 2 event output 2 is selected
• EVENT 12 event outputs 1 and 2 are selected
• EVENT 3 event output 3 is selected
• EVENT 13 event outputs 1 and 3 are selected
• EVENT 23 event outputs 2 and 3 are selected
• EVENT 123 event outputs 1, 2 and 3 are selected
9. The next parameter is SOAK SP:## (## = 1 to 12). It defines the setpoint
after the current ramp segment (##) has completed. Choices are:
• -9999 to 99999
R Dependent upon process variable range
The decimal point defined by the DECIMAL parameter
10. The next parameter is SOAK TM:## (## = 1 to 12). It defines the length
of the current soak segment. Time units are defined by the TIME BASE
parameter in the REC. CONF. menu. Choices are:
D OFF Selecting off eliminates the SOAK and makes possible 2 or more
ramps to different setpoints.
R 00:01 to 99:59 HR:MN if TIME BASE = HOURS:MIN
R 00:01 to 99:59 MN:SC if TIME BASE = MIN:SEC
11. The next parameter is SOAK EV:## (## =1 to 12). It defines which
events will be activated during this soak segment. This parameter will only
appear if
SOAK TM:## is not OFF. Choices are:
D NONE
• EVENT 1 event output 1 is selected
• EVENT 2 event output 2 is selected
• EVENT 12 event outputs 1 and 2 are selected
• EVENT 3 event output 3 is selected
• EVENT 13 event outputs 1 and 3 are selected
• EVENT 23 event outputs 2 and 3 are selected
• EVENT 123 event outputs 1, 2 and 3 are selected
12. The last parameter is PID SET:## (## =1 to 12). It selects which PID
set to use during the current ramp and soak segments. This parameter only
appears if
NO. OF PID = SEG SELECT (in the TUNING menu). Choices are:
D LAST SET