26
Chapter 4
535-PROF User's Manual
Hardware Set Up
Insert module onto connectors
Front of controller
(circuits boards still attached to front face)
V
MA
TCs
RTD
TCt
ASS'Y 535-607
TB1
PV1
2ND
REMOTE SP
CONFIGURATION
PV INPUT
JUMPER
CONFIGURATION
TB2
EPROM
BATTERY
P2
P1
V
MA
TCs
RTD
TCt
Figure 4.4
Install Communications Module onto
Microcontroller Board
SPECIAL COMMUNICATIONS MODULE
A special communications module is available for the 535-PROF; see order code
in Chapter 1 for details.
Equipment needed:
Wrist grounding strap
Phillips screwdriver (#2)
Small flat blade screwdriver
1. Before installing the communications module, set up the hardware wiring
for the application. See Chapter 4 for details.
2. With power off, loosen the four front screws, and remove them.
3. Side the chassis out of the case by pulling firmly on the bezel. Do not detach
the board assembly form the front face of the controller.
4. Orient the Communications Module as shown, and attach it to Connectors
P1 and P2 as shown in
Figure 4.4.
5. To reassemble the controller, properly orient the chassis with board open-
ing on top. Align the circuit boards into the grooves on the top and bottom of
the case. Press firmly on the front face assembly until the chassis is all the
way into the case.
If it is difficult to slide the chassis in all the way, make sure the screws have
been removed (they can block proper alignment), and that the chassis is
properly oriented.
6. Carefully insert and align screws. Tighten them until the bezel is seated firmly
against the gasket.
Do not overtighten.
