MN00178
1359
Figure 2:
EXO Visible / Thermal
with Zoom lens version.
Mounting
The mounting base is drilled with four holes on a 4.75" diameter bolt circle in a 4.0" square base, sized for 1/4" screws. If mounted in a position other than horizontal, the
payload capacity may be reduced. Fasten the base to a stable platform. We recommend 1/4-20" high strength stainless steel bolts and nuts be used. Consideration of wind
and ice load is important when calculating how solid the mounting platform needs to be and the strength required in the mounting screws.
Figure 3:
Base mounting dimensions.
Dimensions shown in brackets
are metric [millimeters] while other
dimensions are in inches.
A selection of QuickSet Mounts are available for wall, pedestal, corner, and pole mounting. When used with the QuickSet wall mount bracket, these provide adequate
clearance for a full 360 degree continuous pan rotation with no interference. Contact your regional Business Development manager for information regarding these
components.
Internal Access
Access to the interior of the pan & tilt housing is not required.
Setting of Pan & Tilt Soft Limit Stops
The tilt soft (software settable) limit is factory set at ±90 degrees. They can be adjusted to values less than the ±90 degree range. There is no pan soft limit in continuous
mode, but there are user adjustable soft limits in the non-continuous rotation mode, when using the Moog PTZ controller. Refer to MN00307.
