MN00178
1359
Point to Point Connections
Point-to-point connections between an Moog EXO Camera and an Decoder can be configured using the device’s web application.
In the Moog EXO web application, in the Configuration section, goes to the Video In tab. Scroll down all the way to the bottom of the configuration page. The last 3
sections are named Point to Point 1, 2 and 3.
Here’s a quick overview of the settings available for a connection:
•
Enabled: Indicates whether this connection is to be used.
•
Description: Free-form user description of the connection, not used by the device.
•
Encoder: Indicates which video feed is to be sent over the point-to-point connection. Possible values include «Primary H.264 » and «Secondary H.264».
These values refer to the encoders configured in previous sections of the same web page.
•
Destination IP: Address where to send the video. This is usually the address of a Decoder. The destination can also be a multicast group address. DNS
names are not yet supported, only IP addresses.
•
Destination Port: Network port where to send the video. This value must match the port value in the Decoder.
Once all the settings have been set, click on Save at the bottom of the page to apply them. The Moog EXO Camera then creates or updates the connection as needed.
Troubleshooting Guide
•
Device does not seem to boot-up
–
Verify that a 24VDC power supply is connected to the device.
•
Cannot discover the device or communicate via the network
–
Before the device can be discovered, the status LED must be lit GREEN as this indicates ready state of the device.
–
Make sure you have connected the device to your network.
–
Dynamic discovery of the Moog Camera requires multicast networking to be supported by your network and switch equipment. (Bonjour Protocol)
