32
Installation
XG0228 - 021419
6HFWLRQΖQVWDOOLQJ 5HPRYLQJWKH'RRU
1
Door Latch Hook
Door Latch Slot
Hand-hold
2
3
4
STEP 3:
Firmly grasp handhold end
of Door buckle tool and
place the machined end in
the slot under door frame.
(as shown)
STEP 2:
Locate door buckles
STEP 1:
Remove the Horizontal
valve blind by placing
ȴQJHUVLQERWKȴQJHUKROHV
then pushing away from
you and lifting out. Place it
aside during maintenance
or cleaning.
Install in reverse order.
TOOLS REQUIRED:
DOOR BUCKLE TOOL
67(3
(QVXUH WKH WRRO LV ȴUPO\
in the lower end of the
slot, (as shown), Then pull
toward you.
STEP 5:
Pull hard if necessary to
release the spring tension.
(Caution: The latch springs
back with force, hold the
tool securely).
STEP 6:
Remove the tool from
the latch slot. Ensure the
latches are hanging freely,
the hook end is released
from the bottom of the
door. (Repeat all 4-steps
for the remaining latches).
STEP 7:
Grasp the door on either side, usually midway and lift upward,
OLIWWKHGRRUFDUHIXOO\XSDQGDZD\IURPWKHIURQWRIWKHȴUHSODFH
3ODFHWKHGRRUDVLGHLQDVDIHSODFHZKLOHPDLQWHQDQFHDQGRU
cleaning is being performed.
5HPRYLQJWKHGRRU
The doors are removed in a few simple steps. Follow these below to
remove the horizontal access panel, unlatch the door buckles and,
remove the door. Replace in reverse order.
Reinstalling the door
To install the door, hook the top edge of the door frame into place.
Lower the door into position and follow the previous steps shown in
reverse order.
When reinstalling the door(s), always make sure all door buckles are
properly hooked and fully engaged.
Figure 20.c
/RFDWHGRRUEXFNOHV
Figure 20.b
5HPRYLQJDQGLQVWDORUL]RQWDO$FFHVV3DQHO
Figure 20.a
Door buckle Tool
Figure 20.d
/RFDWHGRRUODWFKHV
Figure 20.e
3XOOGRRUODWFKHV
Figure 20.f
/LIWWKHODWFKXSZDUG
Figure 20.g
/LIWWKHGRRUXSDQGRXWRIWKHȴUHSODFHIUDPH
Figure 20.h
5HPRYLQJDQGLQVWDOOLQJWKHJODVVGRRUV
WARNING
Door Buckles
