Monterey Sport Cruiser 260SCR, Owner'S Manual, Page: 81 / 212

Section 8
8-14
Cruiser
Horn Switch
The horn switch controls power ON/OFF to sound
the horn.
Blower Switch
The blower switch is used on boats that use an
engine within an engine compartment, such as
stern drive and inboard engines. The switch
controls power ON/OFF to the engine
compartment ventilation blower to remove
explosive fumes from the engine and bilge areas.
Power Trim / Tilt Switch
The power trim/tilt switch controls power ON/OFF
to the engine’s power trim/tilt electric hydraulic
pump. This switch is usually a three-position
switch, with OFF in the center. This system allows
you to raise and lower the drive unit and propeller
to adjust trim (the planing, and running angle of
the boat while under way). The tilt feature
positions the drive unit up beyond the power trim
range and is used for trailering, launching or
beaching. Never use power tilt when the engine is
running.
Figure 8-21
Trim Tab Switches
The trim tab switches control the boat trim tabs’
electric hydraulic pump. Each trim tab has a
separate switch, both switches can be used
independently or simultaneously. Trim tabs adjust
the boat’s trim angle and help compensate for
uneven weight distribution, listing, water
conditions and other factors that contribute to
planing inefficiency. Some switches like the one
pictured have built-in indicators.
Figure 8-22
Windshield Wiper Switch
The windshield wiper switch controls power
ON/OFF to the windshield wipers.
Boarding and Courtesy Light
Switches
The boarding and courtesy switches control
power ON/OFF to boarding lights and cockpit
courtesy lights.
UP
DN
TYPICAL
TRIM
SWITCH
KC-0108-A