MONTAGUE E136W36, Instructional Manual, Page: 7 / 40

7
Ceramic Radiants
Ceramic radiants, Figure 2, are located on
each side of the burners. Ceramic end pieces
are installed at both ends of each burner
assembly. Five (5) ceramic radiants are
installed on each side of the burner with the
pointed side facing down and the side holes
facing up, Figure 3.
Figure 2. Ceramic Radiants Positioning
Figure 3. Ceramic Radiants
1. Insert ceramic end pieces at front and rear
of the burner frame. Four (4) are required for
each burner.
2. Tilt ceramic radiants sideways to clear
burner and frame assembly, then lower
radiant into position with one flange resting
on burner ledge and one flange resting on
frame edge.
3. Install the remaining ceramic radiants so
that five (5) ceramic radiants are located on
each side of the burner.
LOCATION
Adequate clearance for service and proper
operation must be provided at the front, top,
sides, and back. The combustion air openings
are provided in the front of the unit and must
not be obstructed.
SITING
The floor on which the range is to be sited must
be capable of adequately supporting the weight
of the appliance and any ancillary equipment.
Once in position, check that the unit is level,
both front to back and side to side. Adjust if
necessary, using the adjusting foot on each
leg.
BATTERY ARRANGEMENT
Carefully remove range from crate. Burner tie
wires and other packing materials must be
removed from the unit. On stainless steel units,
the protective material covering the stainless
steel must be removed immediately after unit is
installed.
Setting in Place
Model Nos. E36W36, E43W36, E136W36 and
EV136W36. (―W‖ may be replaced with ―C‖ in-
dicating no warming oven. ―36‖ may be re-
placed with ―45‖ indicating a 45‖ broiler.)