MONTAGUE E136W36, Instructional Manual, Page: 30 / 40

30
PILOT BURNER CLEANING AND INSPECTION
PROCEDURE
1. Light the pilot burner as described in the
Installation and Operation section of this
manual.
Figure 14. Pilot Burner
2. If the pilot burner flame burns yellow, clean the
pilot injector and the pilot burner in order to en-
sure a steady blue flame. Clean by blowing
through or washing.
DO NOT use wire to clear
the pilot injector.
3. If the pilot burner flame still burns yellow,
replace the pilot burner and injector.
4. If the pilot flame does not extend 1/2‖ beyond
the outer edges of the pilot, further inspection is
necessary.
GAS TAPS
Re-greasing of the taps is not recommended. If the
tap spindles become seized or difficult to turn, refer
to the
Replacement of Parts section in this manual.
CLEANING BURNER HEADS
1. Remove top panel.
2. Remove top liner panel with insulation.
3. Remove ceramic radiants from the burner frame
assembly.
4. Remove screw from left end of burner head.
5. Loosen thumb screw holding burner Venturi in
place.
6. Remove burner head.
7. Clean the burner with a stiff scrubbing brush
and shake well to endure that the ports are
clear of any debris.
8. Reassemble in the reverse order.
CLEANING BURNER VENTURI
1. Remove top panel.
2. Remove right control panel.
3. Disconnect injector fitting and remove.
4. Loosen thumb screw and slide Venturi out of
the burner head.
5. Clean the Venturi in hot soapy water with a stiff
brush.
6. Rinse and shake well to remove any debris.
7. Reassemble in the reverse order.
CARRIAGE POSITION HANDLE ADJUSTMENT
PROCEDURE
The carriage position handle can be placed in a
number of vertical positions.
1. Grasp the black ball knob and press it in toward
the front control panel.
2. Raise or lower the carriage assembly to the
desired height.
3. Release pressure on the black ball knob to lock
the carriage assembly at the desired height.
Figure 15. Carriage Position Handle
HANDLE TENSION ADJUSTMENT
If carriage is difficult to move or will not stay in
place, the handle tension requires adjusting.
1. Remove black ball knob and chrome sleeve.
2. Turn threaded knob to the left to increase
tension; turn to the right to decrease tension.