Monaco 2009 Knight, Owner'S Manual

Page: 92 / 260

88
2009
K
night
Appliances - 4
Replacing Batteries
Turn remote control OFF.
Remove the battery compartment cover
at the back of the remote by sliding
cover out.
Remove old batteries and insert new
batteries.
Replace
batteries once
a year with two
new alkaline
batteries (1.5V).
Press the RST
button with a
sharp object
to reset the
remote control
before closing
the battery
compartment
cover.




If air conditioner does not operate
normally after replacing batteries,
remove batteries, refit them, and
repress the RST button after 5 seconds.
INFORMATION
Confirm battery type in remote control
before obtaining a replacement. DO
NOT replace with used batteries or
batteries of a different type. This may
cause remote control to malfunction.
FURNAcE
The furnace and related components are
12 Volt DC operated and use propane as the
fuel source. Electronic circuitry (automatic
ignition) ignites the burner. The furnace uses
outside air for burner combustion. Exhaust is
expelled through the outside vent. Inside air
is drawn into the furnace and blown across
the internal heat exchanger. Heated air is then
discharged through ducted hoses that run
throughout the motorhome.
Operating controls are the same hand
held remote used for the air conditioner and
controls on the unit. The controls on the unit
are for an emergency when the remote control
is inoperative or lost and include Emergency
Heat.
TIP
Keep a supply of spare batteries handy
for the remote control. This will ensure
continuous operation of the furnace.

Operation
The furnace operates with a hand held
remote control that sends a signal to the front
roof air conditioner. The air conditioner sends
an electrical signal to the furnace to begin
ignition cycle. There is a small time delay
before the blower motor begins. Once the
blower motor attains a predetermined speed
it will close the air prover or sail switch. The
sail switch, which is now closed, sends the
electrical signal through a high temperature
protection switch, then to the automatic
ignition circuit board. After the thermostat is
satisfied the gas valve closes and extinguishes
the burner. The blower motor stops about two
or three minutes after cool down.
INFORMATION
Refer to the furnace OEM manual for
complete operation information.
Operation Requirements:
Primary propane shut-off valve on the
propane tank is open.
House batteries are charged.
House battery disconnect switch is ON.
Battery cut-out switch is ON.




031344
General Operation for Remote Control
RST Switch
031302b