10
2009
K
night
Equipment - 5
To Move the Bedroom Slide Room (Above
Floor System) Manually:
Turn off both the battery and house
disconnect switches.
The above floor slide-out motor is
located under the bed. Lift the bed and
remove the access panel.
Disconnect
the slide-
out motor
electrical
plug to
remove
12 Volt
DC power
from the
slide-out
motor. The
plug can be
located by
following
wires that run from the motor to the
plug.
Use a wrench to turn driveshaft and
retract room.
Once the slide room is manually
retracted, apply pressure to the wrench
to firmly set the room and prevent
room drift.
Take the motorhome to an authorized
repair center.
CAUTION
DO NOT continue to turn the motor
after the room is fully extended
or retracted. Damage to the slide
mechanism can occur.
To Move the Bedroom Slide Room (Cable
System) Manually:
Turn off both the battery and house
disconnect switches.
Locate the bedroom slide-out motor.
The motor is located near the ceiling of
the slide-out. Remove the trim.
Disconnect the slide-out motor
electrical plug to remove 12 Volt DC
power from the slide-out motor. The
plug can be located by following wires
that run from the motor to the plug.
Attach the flexible shaft to the fitting
on the end of the slide-out motor.
Attach a socket and ratchet or drill
to the other end of the flexible shaft.
reverse the direction. Over-torquing
can cause severe damage.
Turn in proper direction to move the
room. If the cables tighten and the
motor is difficult to turn, reverse the
direction. Over-torquing can cause
severe damage.
Take motorhome to an authorized
repair center.
Broken Cable - Bedroom Slide-Out
If the cable on the bedroom slide-out breaks,
call an authorized repair center for roadside
assistance.
If this is not possible, the slide-out must
be manually pushed in. When pushing, use
extreme care and safety. Take extra precautions
from getting fingers pinched. Avoid getting
fingers near edge of slide wall or around wall
edge.
Push slide-out from the back.
DO NOT
wrap
hands and fingers around edge of slide-out, see
illustration.
Keep fingers away from frayed or broken
cables. Frayed wire is sharp and can cut.
Cables can also jam, then whip free causing
serious injury or death.
Manual Procedure:
Turn off both the battery and house
disconnect switches.
The bedroom slide-out room is heavy.
Use safety and care when pushing to
prevent personal injury. It will require
1-2 people to push the room into
position.
Once the slide-out is in position, take
the motorhome to an authorized repair
center.
030750c
031277d
031294c
Push Here
Don’t Push Here
Summary of Contents for 2009 Knight
