8
2009
K
night
Appliances - 4
Depending on
air conditioner
model, screws
can be found
in different
locations.
Some models
have screws
on front and
rear side, other
models have screws located on both sides. The
illustration indicated is a typical air conditioner
showing possible screw locations.
REMOTE cONTROL
Display
1. Indicates the selected operating
mode.
2. Lights up when the signal from the
remote control is transmitted. The
receiving beep is heard from the unit.
3. Indicates the selected temperature.
4. Indicates the selected or remaining
time of the ON TIMER and OFF
TIMER modes.
5. Indicates the selected fan speed.
6. Indicates the selected timer mode.
Using the Remote Control
1. ON/OFF
BUTTON:
Press this
button
to begin
operation.
(Two
receiving
beeps.)
Press the
button
again to
cease and
operation.
(One receiving
beep.) The
air conditioner compressor will not
operate for three minutes after being
turned off to prevent overloading.
2. MODE SELECTOR BUTTON:
Press this button to select the desired
mode. In COOL mode the unit will
run at the normal cooling mode.
In DRY mode the microcomputer
of the unit controls the fan motor
to automatically cycle on and off
according to room temperature for
efficient moisture removal. In FAN
mode only the fan will operate at the
selected fan speed and circulate the
room air. In FURNACE mode the
unit will run at the normal furnace
mode. In HEAT mode (optional) the
unit will run at the normal heat pump
mode.
3. FAN SPEED SELECTOR
BUTTON:
Press this button to select
HIGH, LOW, or AUTO. In AUTO
mode fan speed is controlled by the
microcomputer of the unit.
4. ON TIMER BUTTON:
Press the
ON TIMER button to select the
desired time, in hours, for the unit to
automatically turn on.
5. OFF TIMER BUTTON:
Press the
OFF TIMER button to select the
desired time, in hours, for the unit to
automatically turn off.
6. TEMPERATURE SELECTOR
BUTTONS:
Set the desired room
temperature for unit to maintain. In
COOL mode, if the room temperature
is higher than the setting, the
compressor will automatically turn
on to provide a cooling effect. If
the room temperature is lower
than the setting, the compressor
will automatically turn off to stop
cooling operation. However, the fan
will continue to circulate air even
if the compressor is turned off. In
HEAT mode (optional), if the room
temperature is lower than the setting,
the compressor will automatically
turn on to provide heat. If the room
temperature is lower than the setting,
the compressor will automatically
turn off to stop heating operation.
However, the fan will continue to
circulate air even if the compressor is
turned off.
031221
Ensure the A/C cover screws
(location as illustrated by arrows)
are tight when the roof is accessed.
031059b
031059
Air Conditioner & Furnace
Remote Control
Summary of Contents for 2009 Knight
