-67-
Revision 6/F3590
©
Moffat Ltd, February 2005
Figure C.
Stacking
12) Remove legs from top unit, place on top of stacking frame, ensure front panel (2) is flush with
sides of both units.
13) Reaching through the rectangular access holes in the side support rails (3) fasten the top unit
to stacking frame with the four 3/8” bolts and washers, thread the bolt up into the foot holes of
the top unit, ensure bolted through correct holes of the side support rails.
14) Remove plastic from side covers (1). Insert tab end into front panel (2) and fasten opposite
end with two screws.
15) Position the chimney (6) on the rear of the units. Secure to the flue duct (5) and bottom unit
with four screws. The holes in the bottom unit may need to be drilled, ø3.5mm (
1
/
8
”).
16) Secure the top of the chimney (6) to the top unit with the chimney support (7) and two screws.
These holes may need to be drilled, ø3.5mm (
1
/
8
”).
17) Ensure that all screws on the stacking kit are tightened.
7.
5.
6.
4.
1.
2.
3.