-41-
Revision 6/F3590
©
Moffat Ltd, February 2005
6.4.8 HOLD TEMPERATURE ADJUSTMENT
1) Open control panel (refer 6.2.1) to gain
access to the hold thermostat (located
inside the control panel).
2) The hold temperature of the oven can be
adjusted by turning the hold thermostat
dial to the desired hold temperature.
Figure 6.4.9
6.4.9 60 MINUTE TIMER ZERO POSITION
ADJUSTMENT
1) Remove 60 minute timer knob by pulling it
firmly away from control panel.
2) Open control panel (refer 6.2.1). Loosen
two screws on control panel holding 60
minute timer.
3) The timer can now be rotated a small
amount as required to ensure that the
buzzer sounds at the zero position.
6.4.6 DOOR ROLLER CATCH
ADJUSTMENT
1) Open the door.
2) Remove the two screws securing the
roller catch to the door and withdraw the
catch (on stainless steel doors the handle
must first be removed).
3) Tighten or loosen the nuts on the catch
assembly to adjust the height of the roller.
4) Refit catch to door and check operation.
Adjust again if necessary.
Figure 6.4.6
Roller catch
Adjustment nuts
5) If necessary the roller catches can be
removed from the door (after removing
handle on stainless steel doors) to adjust
height settings for correction of door catch
operation.
6.4.7 DOOR ALIGNMENT
1) Loosen the five screws along the
bottom edge of the oven front.
Figure 6.4.7
2) Adjust the door position to ensure that it is
square with the oven. Tighten the screws.
Five screws
Hold
thermostat
Figure 6.4.8
Two screws