-30-
Revision 6/F3590
©
Moffat Ltd, February 2005
Four
screws
6.2 ACCESS
Indicator faulty
Check the voltage across the indicator termi-
nals. If the voltage is correct then the indica-
tor is faulty—replace.
If there is no voltage then check wiring.
6.1.15 NO HOLD INDICATOR
Timer faulty
NOTE:
Timer in ‘HOLD’ position (vertical) and
‘Roast n Hold’ switch on (illuminated).
Check the voltage at terminal three of timer,
with timer in hold position. If the voltage is
correct then check wiring.
If there is no voltage then check voltage at
terminal one of timer. If there is voltage at
terminal one, but no voltage at terminal three
with timer in hold position then timer switch is
faulty—replace.
Hold thermostat faulty
With the power switch on and illuminated,
‘Roast ‘n Hold’ switch on and illuminated, and
the roast (180 minute) timer set to hold, check
that the hold indicator is illuminated.
With hold thermostat adjusted above oven
temperature, check for output voltage at
terminal 2 of hold thermostat. If there is no
voltage and the hold thermostat will not switch
on then the thermostat is faulty—replace.
If the voltage is correct but the burner is not
working then check wiring and ignition box.
6.1.16 HOLDING TEMPERATURE
INCORRECT
Figure 6.2.2
6.2.1 CONTROL PANEL
1) Undo the two screws at the bottom of the
control panel.
1) Undo the four screws holding the panel.
6.2.2 SERVICE (SIDE) PANEL
2) The panel can now be removed.
When closing the panel ensure wires and
thermostat capillary tubes are clear of
metal or other terminals.
Figure 6.2.1
2) Remove side panel.
Two screws