INSTALLATION INSTRUCTIONS
2
3
/
4
- 3
3
/
4
"
Lookout Pipe
Finished Wall
8
3
2
2-3"
2-3"
TUB SPOUT INSTALLATION
1/2” copper lookout (pipe protruding from wall)
must be 2 3/4" (70mm) min. to 3 3/4" (95mm)
max. in length and be free of deep scratches,
dents, kinks or bends. The cutoff end must be
free of burrs inside and out. Use of a tubing
cutter is recommended.
IF USING ADAPTER TO INSTALL SPOUT
WITH IPS CONNECTION:
Apply Teflon tape to thread and install into IPS
connection. Tighten with 9/16” socket wrench.
DO NOT use an open end wrench. Cut off 2 3/4-
3 3/4” from finished wall surface. Use of a tubing
cutter is recommended.
TO INSTALL SLIP FIT SPOUT:
Press and twist tub spout
(8)
onto the lookout
upside down and tightly up against the wall.
Tighten set screw with a 3/32" hex wrench until
it just starts to bind. Turn spout upright into
position against the wall and finish tightening
the set screw. DO NOT OVERTIGHTEN.
INSTALL SHOWER ARM
1/2” copper lookout (pipe protruding from wall)
must be 2” (50mm) min. to 3” (76mm) max. in
length and be free of deep scratches, dents,
kinks or bends. The cutoff end must be free of
burrs inside and out. Use of a tubing cutter is
recommended.
IF USING SHOWER ARM ADAPTER (3) - IPS
to CC:
Apply Teflon tape to thread and install
into IPS connection. Tighten with 9/16” socket
wrench; DO NOT use an open end wrench. Cut
off 2-3” from finished wall surface. Use of a
tubing cutter is recommended.
TO INSTALL SLIP FIT SHOWER ARM:
Press
and twist shower arm
(2)
onto the lookout
upside down and tightly up against the wall.
Tighten set screw with a 3/32” hex wrench
until it just starts to bind. Turn shower arm
upright into position against the wall and
finish tightening the setscrew. DO NOT
OVERTIGHTEN.
TO INSTALL SHOWERHEAD
Wrap shower arm thread with teflon tape.
Thread shower head onto shower arm. Tighten
shower head using a wrench on the flats
located on the shower ball. Hold shower arm
with one hand while tightening.
2
3
/
4
- 3
3
/
4
"
2
3
/
4
- 3
3
/
4
"
