sequence after it has been cleaned, be careful
and slide in the bottom and the sidewalls as far
as behind the four projections in the front part of
the chamber.
Before using some other cleaning or
decontamination method different from our
recommendation, it is suitable for the user to
be informed by with the producer whether the
intended method cannot cause damage to the
device.
In case some contaminated material has escaped
into the chamber the user is responsible for
proper decontamination of all contaminated
surfaces with suitable and approved disinfecting.
Cases of volume 22 – EC, dC, iC:
Unbolt the screws in the back part of the ceiling
and of the bottom of the chamber. By pulling out
the walls in the direction to the door you release
the walls and remove them from the apparatus.
When you perform the assembly, you insert the
front bend of the bottom under the holder of the
heating radiator and lock the bottom with a screw.
When you perform the assembly of the ceiling
you put the back part on the sensor holder, put
the front bend of the ceiling on the ceiling holder
and lock with a screw.
(When you perform the assembly/disassembly
of VC, ICV, use the identical procedure, after
releasing the screw of the bottom, you tilt out the
back wall.)
7
maintenance
No special maintenance is necessary. In case of
any troubles, please, call the service.
inspection of electric components:
The cases of thermal technique are destined for
a basic/normal environment, the manufacturer
recommends the inspection period of 1 year, if
not determined by local regulations otherwise.
inspection operations:
Inspection of the electrical installation, particularly
of the electric power supply, of connecting
terminals and a protective terminal.
Check the integrity of the conductor insulation
(for example, due to wearing through, burning
etc.) and the firm connection in the terminals. The
resistance of the protective connection is < 0.1
ohm, the resistance of the supply is not included.
If the case is placed in a different environment,
the inspection must be performed in accordance
with the local standards.
The service inspection is the matter of agreement
between the client and the service organization.
8
warranty
and
service
Warranty is provided by mmm for satisfactory
delivery and functioning of the oven/incubator
within the contractual regulations and during the
warranty period. Specified sales and delivery
conditions shall apply.
MMM does not reimburse any deficiencies or
damages due to normal wear and tear, chemical
or physical attack, natural disaster, excessive
overload, incorrect handling or improper use,
particularly in case of non-observance of
the enclosed Instructions for use, incorrect
installation, as well as in the case of damage
to the system caused by foreign objects or
inadequate maintenance and repairs. By sending
the unit back to the producer (to repair or
exchange at claim), the original package shall be
used. otherwise you take over the responsibility
in the case of damage during the transport
and the producer will reclaim compensation for
possible additional repairs.
For a correct connection to the mains
observe the technical data and instructions
for use.
important:
mmm (the producer) warrants the safety and
technical qualities of the oven/incubator only in
case the repairs and adjustments are done by
the producer or by an organization authorized by
the producer and the components are replaced
with parts approved by the producer and of the
mmm standard.
after a repair has been done, the company
recommends the user to demand a certificate
from the repairer describing the kind and extent
of the repairs, describing the eventual change of
nominal data or extent of the work, containing the
date of the repair, name of the company and a
signature.
9
transport
and
storage
a competent person will prepare the unit for
transport. The unit shall be transported and
stored in its original package. If you send the
device back (for repair or change in case of
claim), use the original package. otherwise
you take over the responsibility for possible
damage during the transport and the producer
will reclaim compensation for possible additional
repairs. Device can be stored in the ambient
temperatures from 0 °C to 40 °C.
Instructions for use
26
LSI_K_np_en 1206_mmm_V2.08_B2V
