MKS Baratron 740C, Manual, Page: 68 / 84

Setup Chapter Five: Type R7xxC Relay System
58
How To Install the Relay Module onto your Transducer
1. Remove the two (2) screws from the top of the transducer.
Refer to Figure 20 for the location of the screws.
Figure 20: Screws on the Top of the Transducer
2. Position the Relay Module so that the holes in the right angle bend of the bracket line up
with the screw holes on the transducer.
3. Replace the two (2) screws, removed in step 1, to secure the Relay Module to the
transducer.
4. Attach the appropriate interface cable from the 9-pin female Type “D” connector on the
Relay Module to the 9-pin male Type “D” male connector on the transducer.
The interface cables are listed in Table 6, page 23.
T w o S c r e w s