OPERATIONS AFTER ENGINE IS WARMED UP
PERIODIC INSPECTION AND MAINTENANCE
2-56
5. Use the commercially-available tool to remove the
engine oil filter.
6. Clean the engine oil filter bracket side mounting
surface.
7. Apply a small amount of engine oil to the O-ring of
the new engine oil filter.
Oil filter number: MD352626
8. Once the O-ring of the engine oil filter is touching
the flange, use the commercially-available tool to
tighten to the specified torque.
Tightening torque: approximately 3/4 turn
(14
±
2 N
⋅
m)
9. Install the engine oil pan drain plug and refill the
engine oil.
10.Install the engine oil filler cap.
11.Race the engine 2
−
3 times, and check to be sure
that no engine oil leaks from installation section of
the engine oil filter.
12.Install the under skid plate and engine room
under cover.
<6B31>
1. Start the engine and allow it to warm up until the
temperature of the coolant reaches 80
°
C to 90
°
C.
WARNING
Use care as oil could be hot.
2. Remove the engine oil filler cap.
3. Remove the engine oil pan drain plug to drain
engine oil.
4. Use the respective tool in the following table to
remove the engine oil filter.
5. Clean the engine oil filter bracket side mounting
surface and ensure the old O-ring has been
removed.
6. Apply a small amount of engine oil to the O-ring of
the new engine oil filter.
7. Where the engine oil filter O-ring touches the
engine oil filter bracket side mounting surface,
tighten the engine oil filter to the specified torque
using the special tool.
ACX00395AD
Commercially-
available tool
AC103250AD
O-ring
Number
Special tool
MD332687 or
MD365876
Oil filter wrench
(MB991828) or
equivalent
MD360935
Oil filter wrench
(MB991396) or
equivalent
AC606008
MB991828,
MB991396
or equivalent
AB
AC103250AD
O-ring
Summary of Contents for Pajero Sport 2013
Page 6: ...NOTES...
Page 16: ...BODY PRE DELIVERY INSPECTION 1 10...
