Mitsubishi Pajero Sport 2013, Inspection And Maintenance Manual

Page: 15 / 94

BODY
PRE-DELIVERY INSPECTION 1-9
Guidelines to give you an estimate of the
labour costs
Approximate labour time to adhere wrap film
How to acquire the wrap film
It will be a direct transaction between O-WELL. Fill
the necessary information, contact information;*1
and ordering quantity;*2 in the specified portion of
the document attached below and send to O-WELL
Corporation. The necessary information is stated in
the document attached below. O-WELL will give you
a quotation in return.
Steps. Process Tips
1 Remove old wrap film Follow the "flow chart of removing the wrap film"
2 Prepare the surface to adhere the wrap
film Make sure there is no debris such as sand or dust. Dry
the surface thoroughly. The temperature of the area to
apply the wrap film should be below 40
°
C for workability.
3 Re-apply the wrap film The area to re-apply the wrap film is the same area
where the original wrap film was applied.
1. Begin adhering the wrap film from the low part of the
vehicle and move upward. Maintain some tension on
the wrap film so it will not get wrinkled or trap air
bubbles. Although air bubbles it self will not damage
the paint, you can avoid trapping air by adhering the
wrap film from the centre to the out side of the
vehicle. Use a tool such as a squeezer to adhere the
wrap film firmly to the vehicle.
2. For moving panels such as the hood and trunk lid, or
portion where parts such as windshield washer
nozzles are pointing out, cut the wrap film
accordingly, so it will adhere to the paint surface
firmly.
3. If the top side of the film (the side without the
adhesive) is left to contact the painted surface, it may
damage the paint surface. (for example, become
lusterless). The edges of the wrap film and
overlapping portions should be firmly adhered to
prevent entry of rain under the wrap film.
4. To prevent colour difference to be recognised
between the areas wrapped and unwrapped due to
exposure to sunlight etc. during storage, we
recommend the boundary of wrapped and
unwrapped areas be on a vertical location.
CAUTION
•
Be careful not to damage the paint surface while cutting the wrap film.
•
Once the wrap film is adhered to the vehicle, it should remain on the vehicle for no more than 6
months. If it is necessary, a new wrap film should be adhered to the vehicle following the steps
above, based on your inventory management schedule.
area to apply wrap film (m
2
) labour time (min)
3.5 - 5.5 10 - 15
5.5 - 7.0 15 - 20