Mitsubishi Pajero Sport 2013, Inspection And Maintenance Manual

Page: 85 / 94

OPERATIONS AFTER ENGINE IS WARMED UP
PERIODIC INSPECTION AND MAINTENANCE 2-57
8. Install the engine oil pan drain plug and refill the
engine oil .
9. Rev the engine a few times, and check to be sure
that no engine oil leaks from the installation
section of the engine oil filter.
<4G64>
1. Start the engine and allow it to warm up until the
temperature of the engine coolant reaches 80
°
C
to 90
°
C.
2. Remove the engine oil filler cap.
3. Remove the under skid plate and engine room
under cover.
WARNING
Use care as engine oil could be hot.
4. Remove the engine oil pan drain plug to drain
engine oil.
5. Use the respective tool in the following table to
remove the engine oil filter.
6. Clean the engine oil filter bracket side mounting
surface.
7. Apply a small amount of engine oil to the O-ring of
the new engine oil filter.
8. Once the O-ring of the engine oil filter is touching
the flange, use the respective tool in the following
table to tighten to the specified torque.
9. Install the engine oil pan drain plug and refill the
engine oil.
10.Install the engine oil filler cap.
11.Race the engine 2
−
3 times, and check to be sure
that no engine oil leaks from installation section of
the engine oil filter.
12.Install the under skid plate and engine room
under cover.
Number Special tool Tightening
torque
MD332687 or
MD365876 MB991828 or
equivalent Approximately
3/4 turn (16
±
4
N
⋅
m)
MD360935 MB991396 or
equivalent Approximately
one turn (14
±
2
N
⋅
m)
Number Special tool
MD136466 Commercially- available tool
MD322508
MD325714 Oil filter wrench (MB991828) or
equivalent
MD332687
MD365876
MD360935 Oil filter wrench (MB991396) or
equivalent
AC612987AD
MB991396,
MB991828 or
commercially-
available tool
Number Special tool Tightening torque
MD136466 Commercially-
available tool Approximately 3/4
turn (17
±
3 N
⋅
m)
MD322508
MD325714 Oil filter wrench
(MB991828) or
equivalent Approximately 3/4
turn (16
±
4 N
⋅
m)
MD332687
MD365876
MD360935 Oil filter wrench
(MB991396) or
equivalent Approximately 1
turn (14
±
2 N
⋅
m)
AC904113
O-ring
AB
(Engine oil)