A - 2
A - 2
[DESIGN PRECAUTIONS]
CAUTION
When storing the product, be sure to observe the defined storage ambient temperature and
humidity. Failure to do so will lead to module malfunction and failure.
Look the control panel so that only those who are trained and have acquired enough knowledge
of electric facilities can open control panel.
Install the emergency stop switch outside the control panel so that workers can operate it easily.
[INSTALLATION PRECAUTIONS]
CAUTION
Use the programmable controller in an environment that reflects the general specifications stated
in the user’s manual of the CPU module used. Using the programmable controller in an
environment out of the general specification range results in the risk of electric shock, fire,
malfunction, and product damage or deterioration.
During installation, fully insert the tabs used to secure the module into the holes of the base unit
while pressing down the module mounting lever located at the bottom of the module, using the unit
holes as support points. An incorrectly mounted module results in the risk of malfunction, failure,
and dropping. When used in an environment of high oscillation, secure the module with screws.
Tighten the screws within the specified torque range. If a screw is too loose, a dropped module,
short circuit, or malfunction may result. If a screw is too tight, screw and/or module damage may
occur, resulting in a dropped module, short circuit, or malfunction.
Be sure to shut off all phases of the external power supply used by the system before module
installation or removal.
Failure to do so results in the risk of product damage.
Do not directly touch a powered section or electronic component of the module. Doing so results
in the risk of module malfunction and failure.
[WIRING PRECAUTIONS]
CAUTION
After the installation and wiring work, be sure to install the provided terminal cover on the product when
you want to activate and operate the module. Failure to do so results in the risk of electric shock.
Fully mount the antenna cable to the module connector. After mounting, check for separation.
Insufficient contact results in the risk of erroneous input and output.
Be sure to place the communication cables and power cables connected to the module in a duct,
or secure them with clamps. Failure to do so results in the risk of cable movement and drift,
module or cable damage caused by careless pulling, and malfunction caused by insufficient
cable contact.
