Mitsubishi AJ65SBT-62DA, User Manual

Page: 56 / 72

5 - 14
MELSEC-A
5 PROGRAMMING
ƒ C ƒ j ƒ V ƒ ƒ ƒ ‹ Ý ’ è • Ï X
ƒ f ƒ B ƒ W ƒ ^ ƒ ‹
’ l Ý ’ è
ƒ A ƒ i ƒ ƒ O
o — Í ‹ – ‰ Â
ƒ G ƒ ‰ [ ƒ Š ƒ Z ƒ b ƒ g
Output range/HOLD/CLEAR
setting (RWw3)
*Initial settings
Initial setting change
*Changing of initial settings
*Processing at initial settings
*Setting of digital values
Digital value
setting
*Analog output enable/disable specification
Analog output
enable
*Processing at error occurrence
Error reset
*Write of remote output signals
Analog output enable/disable
setting (RWw2)
Writes to master station
Writes to master station
Turns on initial data
processing completion flag
(RY18)
Turns on initial data setting
request flag (RY19)
Output range/HOLD/CLEAR
setting (RWw3)
Analog output enable/
disable setting (RWw2)
Writes to master station
Writes to master station
Turns on initial data setting
request flag (RY19)
Turns off initial data
processing completion flag
(RY18)
Turns off initial data setting
request flag (RY19)
CH.1 digital value setting
(RWw0): 500
CH.2 digital value setting
(RWw1): 1000
Writes to master station
Turns on CH.1 analog output
enable/disable flag (RY00)
Turns on CH.2 analog output
enable/disable flag (RY01)
Read CH. check code
(RWr0,RWr1)
Read error code (RWr2)
Turns on error reset request
flag (RY1A)
Turns off error reset request
flag (RY1A)
Y400 to Y41F are written into
RY00 to RY1F
* The program enclosed by the dotted line is necessary only when the initial settings
are changed.