Mitsubishi AJ65SBT-62DA, User Manual

Page: 35 / 72

4 - 3
MELSEC-A
4 SETUP AND PREPARATION BEFORE OPERAATION
4.3 Name of Each Part
The name of each part in the AJ65SBT-62DA is shown.
DA DG
1 3 5 7
24G
DB SLD
2 4 6
(FG)
+24V
NC NC NC
9 11 13 15 17 19 21 23 25
8 10 12 14 16 18 20 22 24
TEST NC
TEST COM NC
V+ I+ NC V+ I+ NC NC
NC COM NC
2-piece
(CC-Link
communication
section)
Direct-coupled
(Analog I/O section)
Terminal numbers and signal names
PW RUN L RUN L ERR. CH1 2 OFFSET GAIN
MITSUBISHI A
J65SBT-62DA
DA DG +24V 24G
DB SLD (FG)
TEST
TEST NC
V+ I+ NC NC
COM NC NC COM NC NC NC
V+ I+ NC NC
CH1 CH2
SELECT
SET
UP
DOWN
STATION NO. B RATE
40 20 10 8 4 2 1 4 2 1
ON
MELSEC
1) 2) 3) 4) 5) 6)
7)
8)
Number
Name and
appearance
Description
PW LED
ON: Power supply on
OFF: Power supply off
Normal mode
On : Normal operation
Flashing : 0.1s intervals indicate an output range setting error.
0.5s intervals indicate a digital value setting error.
Off : 24VDC power supply shutoff or watchdog timer error
occurred.
RUN LED
Test mode
On : Indicates that the SELECT/SET switch is in the SET
position.
Flashing : 0.1s intervals indicate that the output range setting is
not any of "user range settings 1 to 3".
0.5s intervals indicate that you attempted to make
offset/gain setting outside the setting range.
Off : Indicates that the SELECT/SET switch is in the
SELECT or center position.
L RUN LED
On : Normal communication
Off : Communication cutoff (time expiration error)
1)
Operation status
display LED
L ERR. LED
On : Indicates that transmission speed setting or station number setting is
outside the range.
Flicker at fixed intervals : Indicates that transmission speed setting or station
number setting was changed from that at power-on.
Flicker at unfixed intervals : Indicates that you forgot fitting the termination resistor or
the module or CC-Link dedicated cable is affected by
noise.
Off : Indicates normal communications.
Normal mode Normally OFF.
2)
Offset/gain
adjusting LEDs
CH
OFFSET
GAIN
Test mode
The LEDs lit change every time the SELECT/SET switch is moved
to SELECT. (Refer to Section 4.4.)
3)
SELECT/SET
switch
Used to make offset/gain setting in the test mode.