Mitsubishi MOTORS Eclipse 1997, Service Manual

Page: 386 / 540

Starting System Engine
ENGINE ELECTRICAL
(Turbo)
SERVICE SPECIFICATIONS
Standard value
Free running Terminal voltage
11
characteristics
Current A
90 or less
Speed
3,000 or more
I
Pinion gap mm (in.)
I - I
Commutator mm (in.) 0.05
0.1
I
Commutator diameter mm (in.)
(1.158) 28.4 (1.118)
I
Undercut depth mm
0.5
I
TROUBLESHOOTING
TROUBLESHOOTING GUIDE
The starting system troubleshooting guide shown in the following chart. ,
Check battery
Charge or replace ‘battery
I
to GROUP 54
OK
OK
Disconnect starter motor terminal connector
l
Using jumper wire, apply battery voltage to starter motor
terminal
l
Check enaine condition
OK: normally
NG
l Check ignition switch
(Refer to GROUP 54 Switch)
l
Check starter relay
l Check clutch pedal position switch
(Refer to GROUP’ 17 On-vehicle Service)
l Check switch
[Refer to GROUP On-vehicle
l
Check line between motor
Check theft-alarm ‘system
circuit equipped*
(Refer to Theft-alarm
,
Excessive rotational resistance of engine
H I N T S
The starter motor does not operate.
l
Check the starter (coil).
l
Check for poor contact at the battery terminals
and starter.
l
Check park/neutral position switch.
l
Check starter relay.
l
Check clutch position switch.
l Check theft-alarm starter relay.
l
Check key reminder switch.
TSB Revision
l Check cable between starter terminal and battery positive
terminal for connection and continuity
r e p l a c e c a b l e
Check starter motor (Refer to