Mitsubishi MOTORS Eclipse 1997, Service Manual

Page: 524 / 540

CHASSIS ELECTRICAL- Theft-alarm: System
S Y S T E M ,
The of the system can” by
following the steps below.
(1) Turn the ignition key to ON position
the power-window to open on
the ‘side.
.
(2) Turn the ignition key to the LOCK position and
the key from the
(3) Open only the driver’s and close
including the
(4) drivers door the or the
(5) All will then locked, and the SECURITY light
(within the will illuminate; Check
illumination stops in about
(6) After about passed after the SECURITY
light switched off, reach through the window of the
door, pull, up the lock lever to unlock the door, and
open the door.
(7) Check that, when the is opened, the horn starts
sounding and the headlights flash off, ,
(6) To stop the alarm, the into
and turn the key.
NOTE
To check the alarm for the or hood, pull the remote,
release lever before the alarm is activated by the opening
of a door or after the first three-minute alarm.
54700130023:
INPUT SIGNAL INSPECTION POINTS
When the
1. Connect the tool to data link connector.
Caution
Always turn off the
switch when
and disconnecting tool.
2. If buzz& of the’ scan” tool Sounds once a switch
is operated (ON/OFF), ECU input signal for that switch
circuit system is
When Using a Voltmeter
1. Use the special tool a-voltmeter the’
ground terminal and the ETACS terminal of data link
If the voltmeter indicator deflects once when a switch
is operated (ON/OFF), the ECU input signal for that switch
circuit system is normal.