Mitsubishi MOTORS Eclipse 1997, Service Manual

Page: 515 / 540

Radio, Tape Player, CD
CHASSIS ELECTRICAL
Amplifier, Speaker and’
Rack cable
Rack cable teeth
A N T E N N A P O L E , R E P L A C E M E N T
Remove the ring nut.
(2) After turning the ignition switch to ACC or ON, the
radio switch to ON to raise the antenna pole, and remove
it, together with the rack cable.
(3) Draw out the antenna pole to the maximum extension..
N O T E
If there is a bend in the motor end of the rack cable,
remove the
(4) Insert the rack cable into the with the
rack. cable teeth facing luggage room
side.
(5) the rack cable teeth towards the rear of vehicle
(right so that the rack cable meshes with the
(6) rack cable pulls out with no resistance when it
is, lightly pulled, then the cable is not meshed the
motor gear, so check that there are no bends in the end
of the rack cable, and then repeat steps (4) and (5) above.
(7) Set the antenna pole vertically and the radio switch
OFF to wind up the rack, cable. Insert the to
the motor antenna side align it with the wound-up
rack cable.
(8) After tightening the ring nut, check the movement of the
antenna by turning the radio switch ON and OFF.
TSB Revision