Mitsubishi Fuso CANTER, Owner'S Handbook Manual

Page: 397 / 467

12-95
•
Single nut type
Tighten the wheel nuts to the specified torque. Fol-
low the diagonal tightening sequence indicated in
the figure.
•
Double nut type
Retighten the wheel nuts using the following 2-pro-
cess procedure.
1st process
Loosen the outer wheel nuts as follows:
5-stud wheel type: Loosen the nuts numbered 1
– 2 – 3 or 4 – 5 in the figure in this order.
6-stud wheel type: Loosen the nuts numbered 1
– 4 – 5 or 2 – 3 – 6 in the figure in this order.
Tighten the inner wheel nuts corresponding to
the loosened outer wheel nuts to the specified
torque.
Tighten the loosened outer wheel nuts to the
specified torque.
2nd process
Perform the above steps through for the
remaining outer wheel nuts and inner wheel
nuts.
NOTE:
The wheel bolts and nuts on the right-hand wheels
have right-hand threads, and those on the left-hand
wheels have left-hand threads.
The bolts and nuts have stamped marks for easy
identification; an “R” mark for right-hand wheels and
an “L” mark for left-hand wheels.
WARNING
In the case of dual wheels, one often retight-
ens outer wheel nuts while forgetting to
retighten inner wheel nuts. Always follow the
above procedure to tighten all the nuts.
1
1
3
4
5
2
6
2
3
4
5
Z09311
Z09315