4. SSCNET COMMUNICATION DRIVERS
4
−
4
4.1.2
When using the A30BD-PCF interface board
This section provides the SSCNET communication driver setup procedure for use
of the interface board.
1) The SSCNET Communication Driver Setup window
appears.
Choose "A30BD-PCF Board Type" and click [Detail].
*You need not make the setting when you use
RS232C communication or do not use SSCNET
communication.
Click [Cancel] to exit from SSCNET Communication
Driver Setup.
2) Check and set the free areas of IRQ Level and
Memory Base Address.
Click [OK].
*For the way to check the free areas, refer to "4.2
How to Check the System Resources".
12
34
ON
1
234
ON
5678
SW3
SW
4
SW2
SW1
12
34
ON
3) The data set in the Detail Setting window must be
reflected on the switch setting of the interface board.
Refer to "4.3.1 Setting the A30BD-PCF Interface
Board" and make the switch setting of the interface
board.
4) Click [OK].
To next page
