2. SYSTEM CONFIGURATION
2
−
6
POINT
(1) The interface board and interface card cannot be used together.
(2) On some personal computers, the digital oscilloscope may not perform
sampling.
In that case, use the card enabler supplied by the personal computer
maker or check the PC card controller settings (BIOS settings). (For the
BIOS settings, refer to the manual of your personal computer.)
(3) For Windows 98/2000, insert the interface card into the personal
computer after installing SNETP and setting up the SSCNET
communication drivers.
(SNETP can be reinstalled with the interface card loaded.)
(4) If, after SSCNET communication has been made, you remove the
interface card and boot the personal computer without that card being
reinstalled, Windows NT may not start or may not run properly.
For Windows NT, you need to stop the SSCNET communication driver
when removing the interface card.
For the way to stop, refer to "4.5 Stopping the SSCNET Communication
Driver".
(For Windows 98/2000, use the plug and play function to remove. Using
this function will not cause such phenomena.)
(5) The interface cards can be used in the following environment.
Windows 98
Windows NT
Windows 2000
A30CD-PCF interface card
Usable:
•
