Chapter 10 Adjustment
10–8
(3) Adjusting the in-position width
Because there is a response delay in the servomotor drive due to position loop control, a "settling
time" is also required for the motor to actually stop after the command speed from the CNC
reaches 0.
The movement command in the next block is generally started after it is confirmed
that the machine has entered the "in-position width" range set for the machine.
Set the accuracy required of the machine for the in-position width. If an unnecessarily high
accuracy is set, the cycle time will increase due to a delay in the settling time.
The in-position width is effective even when the standard servo parameters are set. However, it
may follow the CNC parameters, so refer to the CNC Instruction Manual for the setting.
No.
Abbrev.
Parameter name
Unit
Explanation
Setting range
SV024 INP In-position
detection
width
µ
m
Set 50 as a standard.
Set the precision required for the machine.
0 to 32767
POINT
The in-position width setting and confirmation availability depend on the CNC
parameters
