Mitsubishi Electric GUG-01SL-E, Technical Manual

Page: 34 / 76

31
CHAPTER
7
Remote Controller PZ-01RC /
5. Initial setting
5. Initial setting
Before starting to operate of the system, the following setting are required.
(1) For the SA temp. control, set the Room temperature not to be displayed using the following steps.
Note:
For the RA temp. control, if the display is necessary please skip this setting.
[Default display]
(2) Function setting from remote controller PZ-01RC.
(Automatic recovery setting)
[Function No.01]
Please change this function to “Not available
” .
If automatic recovery needs to be used, set it from Lossnay unit. Refer to the Lossnay installation manual for details.
Function No. Setting data Setting check Contents
01
1 Not available
2
(Factory setting)
Available
The function setting below must be set as the factory setting.
If changed, please set to the factory setting.
No. Factory setting data
02 1
03 1
04 2
05 2
06 2
07 3
15 1
16 1
17 1
21 1
24 2
28 2
Note:
The factory setting of No.08, 09, 10, 11, 12, 13, 14, 18, 19, 20, 22, 23, 25, 26 and 27 are not set and the function is not
available.
Main menu:
Cursor Page
Initial setting menu 1/2
Main/Sub
Clock
Main display
Contrast
Display details
Fri
Mode Temp.
Cool
Set temp.
[Step1]
From the Main display, select “Main
menu” -
>
”Initial setting” -
>
“Display
details” .
[Step2]
Move the cursor to the “Room temp” .
on the display details setting screen,
and select “No” with the F3 or F4
button. (Factory setting is “Yes” .)
[
Step3]
Check that “Room temperature” is
not displayed.
Fri
Mode Temp.
Room
Cool Set temp.
Select:
Cursor Cursor
Display details
Clock
Temperature
Room temp.
Auto mode
No 24h
°C / °F / 1°C
Yes / No
Yes / No