(16/71)
7. Setting method
Procedures for setting
Set items such as phase wire system, primary voltage, and primary current in the setting mode to measure and monitor.
Under normal use, it shall be sufficient to set the setting menu 1 (Basic setting) only.
For details, refer to after the following page.
<How to set>
(1) Go into the setting mode by pressing both and at the same time for 2 sec.
(2) Select the setting menu number by pressing or .
(3) Determine the setting menu number by pressing .
(4) Set each setting item.
(5) After all setting are done, select “End” on the setting menu and press .
(6) When prompted for End display, select “End” and press .
Caution
･
Setting menu 5 related to the logging Unit is shifted to Setting mode from Operating mode, and
Please go in a procedure to set only Setting menu 5.
・
If you change setting, related setting items and measured data are initialized.
Please check them beforehand.
page 31
Phase wire system
Factory default
Primary voltage
(use or non-use of
VT)
Primary voltage
(With VT or Direct)
Primary current
Secondarycurrent
Current demand
time
Model Name
MODBUS®RTU
address
MODBUS®RTU
baud rate
MODBUS®RTU
parity
MODBUS®RTU
stop bit
Contact / pulse
input
Reset method
of contact input
Contact / pulse
output
"End" display
Unit amount of
pulse output
※
3
Equivalent CO2
indication
※
4
CO2 conversion
factor
※
5
Harmonic current
indication
Harmonic voltage
indication
Operating time
indication
Counting method
of operating time
※
2
Primary special
voltage
Secondary special
voltage
Primary voltage
(VT voltage)
※
1
※
2
Operating mode
Measurement display
Fix of setting
value change
Cancel of setting
value change
"CANCEL" display
Transition automatically
Example of setting
mode display
Example of confirmation
mode display
End of setting menu
Setting menu 1
Basic setting
Setting menu 2
Communication setting
Setting menu 3
Input/output setting
For the special voltage (SP)
(Not available for 1P3W)
※
11
- / RESET
SET
+ / PHASE
- / RESET
SET
SET
SET
