Safety, Operation, & Maintenance Manual
Linear Cut Processing Systems
45
•
Infeed Loader > Stop
– Stops the infeed conveyor.
•
Infeed Loader > Reverse
– Runs the infeed conveyor in reverse away from the
infeed pusher assembly.
•
Infeed Loader > Forward
– Runs the infeed conveyor in a forward direction
toward the infeed pusher assembly.
•
Outfeed > Conveyor Motor
– Turns the outfeed conveyor motor on.
•
Outfeed > Kicking Far/Near
– This button toggles the outfeed kicking system to
either use the “Near” kickers closest to the central operator of the system or the
“Far” kickers furthest from the main operator location (if equipped).
•
Outfeed > Test Kickers (Out/In)
– Used to for testing purposes only to
check functionality of all pneumatic kicking mechanisms. Pressing “Test
Kickers (Out)” will execute all kickers to extend out. Pressing “Test
Kickers (In)” will retract the kickers back to their normal position.
Note: The system does not allow running the outfeed with the
kickers extended out nor should the operator attempt to run the
system with the kickers extended out.
•
Outfeed > Speed (Medium/Fast)
– An option available to certain
models is the existence of multiple speeds. Used to switch the
conveyor speed to one of two speeds: “Medium” or “Fast”.
Note: Speed controls of this button are not relevant when in Cut Set
Operations Mode. When in Cut Set Operations Mode, speeds are
determined by each material type in the Materials Library settings of the
software.
