Safety, Operation, & Maintenance Manual
Linear Cut Processing Systems
47
7.2
Pre-Operation Physical Checks
Perform all safety checks before using the saw. See
information.
Preparing the Printer
Perform the following checks on the edge printer and the bottom plate printer
(if equipped) before operating the saw for best results. See the
section
for more information regarding replacing cartridges and testing the printers.
1.
Visually inspect the nozzles on the front of the inkjet cartridges.
2.
If any noticeable damage to any cartridges is found, replace the cartridge.
3.
Clean, purge, and test the printer.
8
Operation
8.1
Start Conditions
Powering Up the Motor Controls
The motor controls for the pusher must be powered on before operation may begin.
The button for powering on the motor controls can be found on the bottom panel of the
CutBuilder software.
Homing the Pusher
After powering on the motor controls, the pusher must be homed.
To begin homing, press the
Home
button which is located in the bottom panel of the
CutBuilder software.
NOTE: If the home button is flashing in color, this indicates homing is
required and is the only option.
