Miscea Light CCR1S1NCDE, Instruction Manual

Page: 33 / 84

V 20.06
33
English
10. Service
WATER RELATED PROBLEMS
Symptoms Experienced
Possible Problem or Cause Solution
• The faucet is leaking/dripping
water. If newly installed, the mains water
supply was not flushed thorough -
ly enough before installation,
resulting to dirt particles entering
the system causing problems with
components inside the system.
Disconnect the miscea system
from the power point. After 10 sec-
onds, reconnect the miscea system
to the power point. This should
reset the system and resolve any
minor system glitches.
Flush the faucet by letting the
water run for a few minutes.
If the problem persists, please
contact miscea GmbH for further
technical assistance.
• The faucet is dispensing wa-
ter on its own (ghost water) The sensor in the sector is dirty.
Issue with sensors in faucet head.
Possible environmental factors
such as bright light or super reflec -
tive surfaces affecting the sensors.
Switch the faucet off, and clean
the sensor ring in the sector with a
damp cloth.
If problem persists, please contact
miscea GmbH for further technical
support.
• The water stream is very
weak. The mains water supply is not
completely set to open.
The shut off valve (if available) is
not completely set to open.
Check the mains water supply is
set to completely open.
Check the shut off valve (if avail -
able) is set to completely open.
If the problem persists, please
contact miscea GmbH for further
technical assistance.
SOAP/DISINFECTANT/LOTION RELATED PROBLEMS
Symptoms Experienced
Possible Problem or Cause Solution
• Only a small amount of
soap / disinfectant / lotion is
dispensed.
• Too much soap / disinfectant
/ lotion is dispensed.
The pre-selected amount of dis-
pensed liquid is to high/low.
You can adjust the amount of
dispensed liquid with the remote
control.
Contact miscea GmbH for further
technical assistance.