Miscea Light CCR1S1NCDE, Instruction Manual

Page: 31 / 84

V 20.06
31
English
Service
To resolve problems, follow the table error / cause / solution. In the case of maintenance work on the
system, the power supply must first be switched off!
If the problem cannot be solved, disconnect the power supply. Write the serial number of the faucet and
contact a qualified installer or contact miscea by email at
berlin@miscea.com.
The table below provides helpful hints and solutions for troubleshooting the miscea LIGHT System as
well as scenarios for possible hardware and software problems.
Before contacting miscea Technical Support
If you are having problems with your miscea LIGHT System try the appropriate solutions below to isolate
the exact problem before contacting miscea GmbH for further technical support.
1. Check the system is plugged into a working electrical outlet and switched on.
2. Check the system is connected to the mains water supply and the water supply is turned on.
3. Check the pouches containing the liquid hand products are installed and not empty.
4. Check all cable and tubing connections for loose connections or incorrect connections. Please
refer to appropriate manual for correct installation procedures.
Solving General Problems
You may be able to easily resolve general problems described in this section. If a problem persists and
you are unable to resolve it yourself or if you feel uncomfortable about performing the operation, please
contact your nearest miscea technical support.
10. Service
WATER RELATED PROBLEMS
Symptoms Experienced
Possible Problem or Cause Solution
• The water won’t stop. There is an issue with the solenoid
valve. Disconnect the miscea system
from the power point. After 10 sec-
onds, reconnect the miscea system
to the power point. This should
reset the system and resolve
any minor system glitches. If the
problem persists, please contact
miscea GmbH for further technical
assistance.