Miscea Light CCR1S1NCDE, Instruction Manual

Page: 19 / 84

V 20.06
19
English
CAUTION
• Do not connect the faucet to a water supply that has no strainer. If you do, the warranty
becomes void.
• Do not install hoses when the faucet is switched on or when the power adapter is connected.
• Do not hold any object close to the faucet head when the calibration is in progress. This can
block the light and interfere with the calibration.
• Do not install or store the faucet in a location that has the risk of frost damage.
• Be careful with the power cable of the faucet and the soap box. The connector at the end of
each cable is fragile.
• Make sure that the hoses for the liquids are correctly connected.
• Do not cut or kink the hoses.
• Only use the supplied materials to install the system. Only use the power adapter supplied
with the system.
• Use only genuine replacement parts and accessories. The use of other parts will invalidate
the warranty and CE marking and may result in personal injury.
• Avoid damage from defective power supply cables. In the case of damage, the plug-in power
supply must be replaced by the manufacturer or his customer service or an equally qualified
person.
3. Description
3.1 Components
Refer to fig. C for the identification of the components.
1. Faucet (1A or 1B)
2. *Soap box (5a/b)
*Only available for models with integrated dispenser
3.2 Identification of the product
Refer to fig. C for the location of the product type labels.
3.3 Application areas
miscea systems can be used in conjunction with:
• Pressurized storage heaters
• Thermally controlled instantaneous heaters
• Hydraulically controlled instantaneous heaters
Operation with low-pressure displacement water heaters is not possible.
The miscea LIGHT is certified according to EN1717, and is equipped with a DIN-DVGW type tested back
flow preventer.
4. Installation