23
To change the freeze mode follow these steps:
1. Press SELECT to enter the menu.
PROC
is displayed.
2. Press the “ + “ push-button until
FRZE
is displayed.
3. Press
SELECT;
MODE
is displayed.
4. Press SELECT to enable the Freeze Mode menu. The current Freeze Mode
selection is displayed.
5. Use the “+” or “–“ push-button to choose the desired Freeze Mode setting.
Press the “+“ and “–“ push-buttons simultaneously to set Freeze Mode to
ERR
(default setting).
6. Press SELECT to store the new Freeze Mode setting.
MODE
is displayed.
7. Press ESC to return to
FRZE
.
8. To return to normal mode, press ESC.
Table 3.1
Freeze modes
Freeze mode selection
Freeze mode description
ERR
(error)
Execute a freeze if an error has been detected in the input
signal
LOSS
(loss)
Execute a freeze if there is a loss of input signal
OFF
Automatic Freeze is disabled
Note: When a freeze condition occurs, the horizontal and vertical blanking
intervals (HANC and VANC) are blanked
3.8.2 Freeze Type
The Freeze Type menu selects the type of image freeze to be executed if it is
enabled by the Automatic Freeze Mode. Refer to Table 3.2 for a description of
each type of freeze.
To change the freeze type follow these steps:
1. Press SELECT to enter the menu.
PROC
is displayed.
2. Press the “+“ push-button until
FRZE
is displayed.
3. Press
SELECT;
MODE
is displayed. Press the “+“ push-button until
TYPE
is
displayed.
4. Press SELECT to enable the Freeze Type menu. The current Freeze Type
selection is displayed.
5. Use the “+” or “–“ push-button to choose the desired Freeze Type setting.
Press the “+“ and “–“ push-buttons simultaneously to set Freeze Type to
FRM
(default setting).
6. Press SELECT to store the new Freeze Type setting.
TYPE
is displayed.
7. Press ESC to return to
FRZE
.
8. To return to normal mode, press ESC.
Table 3.2
Freeze types
Freeze type selection
Freeze type description
Summary of Contents for DVP-101i
Page 36: ...31 5 Schematic DIagrams ...