7
Figure 2.3
Location of ABUS (Audio Bus) connectors on DVP-101i module
2.2.3
imaging
Solo Housing Frame
To install this card into Solo follow these steps. For a closer look at card
installation and removal, refer to the housing frame's
Guide to Installation and
Operation
.
1.
In order to remove the housing frame's front panel, gently pull on it.
2.
Carefully place the DVP-101i between the card guides and gently push the
card towards the rear of the housing frame until the card's edge connector is
secured to the backplane. Pull lightly on the card verifying that it does not
move.
3.
Replace the housing frame's front panel.
2.3 Rear Panel Label
2.3.1
imaging
Quartet/Quartet-C/Quartet-M/Solo Connector Label
Connector labels have been shipped with your DVP-101i. Select the label according
to your housing frame model. This label is to be installed on the housing frame's rear
panel in order to identify the DVP-101i external connectors. To install the label, follow
these steps.
1.
Remove the screws associated with the DVP-101i connectors.
2.
Carefully apply the label to the connectors as shown in Figure 2.4.
3.
Replace the screws making sure not to damage the label.
Display
FREEZE
TEST
SELECT
ESC
-
+
525
625
ERR
EDH FS
REF
INPUT
1
3
2
4
AUDIO IN
DETECTED
DVP-101i 4:2:2 DIGITAL VIDEO PROCESSOR/SYNCHRONIZER
AB
U
S
#1
AB
U
S
#2
ABUS #2 Connector
ABUS #1 Connector
Summary of Contents for DVP-101i
Page 36: ...31 5 Schematic DIagrams ...