25
/
36
4 Operation
4.1 Notices
To avoid any harm to the human body and equipment,
please read the following information carefully.
Do not
attempt to maintain the equipment by the person not
professional.
Ensure the power supply, water chiller and cutting accessorial gas are
subject to the requirements in section 3.4.
Check up to ensure that the ground is properly earthed.
Check up to ensure that all connections and all pins and board are credible.
Preparation before power on
1.
Please read the operating manual and electric principle diagram
carefully.
2.
Check up the main power supply switch.
3.
The ground of main power supply cross section area is more than 4mm
2
.
4.
The air pressure of the accessorial air source is not less than 0.6MPa
and the working air pressure range is from 0.02 to 0.4MPa.
4.2 Introduction
MINTECH 1325 / 1530 adopts PC-Based motion controller, it can operate on
Windows.
The characteristic of the program
1.
This program can import
DXF
files.
2.
Text can be translated into combined object and the objects can be
combined and split.
3.
You can array, cut, copy and paste objects.
4.
You can define speed and laser power and the cutting quality is superior.
5.
You can define different cutting parameters in different cutting objects.
6.
You can select any objects from the graphics area to cut.
