11
/
36
The water cooler system should have been running for ten minutes
before operating the cutting machine. And check the whole water
cooler system, to ensure there are no air bubble in the pipe.
Before operating the cutting machine, check each
parameter setting, to ensure there are no air bubble in the
pipe. Otherwise,
Laser pipe will break.
Check to make sure that all the indicators of the laser and laser power
module are all right.
There is a yellow-lamp on the frame of machine. When laser on, the
lamp is turned on.
Simulated run the new program when the laser does not work, and
check to make sure the program logic is correct.
1.3.4
Safety instructions after the machining finished
Press the emergency " stop ", then switch off the main power supply of
the machine, finally, switch off the workshop power supply.
1.4 Safety instructions in maintenance
The maintenance of this laser cutting machine must only be carried out
by trained, professional staff.
The maintenance should be carried out on the condition of power off.
Don't change the position of the limit and the control switches.
