ADJUSTING THE PULL GRIP AND CABLE
3
g. Once the Cable has been cut to length, take the
Pull Grip and pull the Cable back into place until
it is seated against the Latch Strap Cable Pull
Bracket.
h. After the Cable is in place, refer to the Removal
of the Steering Module section and follow the
precedure to Reassemble the Steering Module.
2
Cable
Cable
Pull Cable Clamp
Pull Cable Clamp
Adjust Cable
Set Screw
Aluminum Arm
c. Grasp the Pull Cable Clamp and Cable and pull it
out of the Aluminum Arm.
d. The Pull Cable Clamp contains two Set Screws.
Loosen, but do not remove, these two screws
with a 5/64 Allen Wrench until the Cable can slide
in the Pull Cable Clamp.
e. Adjust the Cable to the desired length. Retighten
the two Set Screws using the 5/64 Allen Wrench.
Tighten the Set Screws to 16-19 in-lbs.
f. Using a Hack Saw, trim the Cable so there is no
more that 1/16" excess beyond the Pull Cable
Clamp.
Cable
Latch Strap Cable Pull Bracket
Pull Grip
Pull Cable Clamp
Aluminum Arm
1/16"
Maximum
