ORIENTATE THE PEDAL CONTROL SLEEVE ASSEMBLY FOR A STARBOARD MOUNT
11
Wrap Drum Cover
Wires
Steering
Module
Screws
9
10
CAUTION
Do not over tighten the Cable Tension Screw, as excessive
tension will cause damage to the unit.
10q
Cable
Tension
Screw
Toe End of
Foot Pedal
Cable Anchor
Wrap Drum
Cover
Steering Motor
Connection Wire
n. Re-tighten the two screws that fasten the Cable
Anchor to the top of the Steering Module using a
#2 Phillips screwdriver. Tighten to 25 in-lbs.
o. Using a #3 Phillips screwdriver, tighten the Cable
Tension Screw located at the base of the Toe
End of the Foot Pedal to 10 - 12 in-lbs until the
Steering Cables are under tension or re-tighten
the same number of turns as was used in step 4f.
p. Reconfirm that the Steering Cables are tight
and then carefully thread the Steering Motor
Connection Wire through the top of the Wrap
Drum Cover. The male plug comes from the Cable
Anchor through the opening at the bottom of the
Wrap Drum Cover. The wire with the female plug
that runs out the top of the Cable Gear should
also be pulled through the opening at the bottom
of the Wrap Drum Cover.
q. Place the Wrap Drum Cover down on top of the
Cable Anchor and align the screw holes on it with
the screw holes on the Cable Anchor. Make sure
the Wrap Drum Cover is nested securely on top of
the Steering Module and that the wires pass out
the top of the Wrap Drum Housing. Secure the
Wrap Drum Housing in place with the two screws
that were originally removed using a #1 Phillips
screwdriver. Tighten to 6 in-lbs.
Cable Anchor
Screws
Steering
Module
10p
CAUTION
Take care not to pinch the Steering Motor Connection Wire
while the Wrap Drum is set into place.
