INDEXING THE MOTOR
1
a. Turn the Power Switch "on" and steer the motor
so that the Control Head is in line with the keel of
the boat. This can be done by steering the motor
with the Foot Pedal, turning the motor with
the remote, or manually turning the head of the
motor.
b. Leave the Control Head in the desired alignment
and turn the power to the Foot Pedal "off". Then
disconnect the power by removing the power
cables from the battery or turning "off" the
breaker if equipped.
Foot Pedal
Power Switch
Deck of
Boat
Pedal Control
Sleeve Assembly
Control Head
Control Head
Alignment
Keel
WARNING
To avoid electric shock, make sure the motor is not
connected to a power source.
2
c. Remove the Connector Cover from the Wrap
Drum Cover using a 1/8” wide Flat Screwdriver
to release it. Release it by pressing the flat part of
the screwdriver in the slot closest to the center of
the Connector Cover and prying upwards.
d. Once the Connector Cover is removed,
disconnect the Steering Motor Connection Plug
that is visible.
NOTE:
Please note the orientation and routing of
the plug and wires for re-installation.
2c
2d
Connector
Cover
Wrap Drum
Cover
Wrap Drum
Cover
Connector
Cover
Flat
Screwdriver
Steering Motor Connection Plug
