ADJUSTING THE PULL GRIP AND CABLE
a. With the Gas Spring Pin disconnected, and the
Steering Module removed, make sure the mount
is in the deployed position.
1
The length of the Cable on the Pull Grip and Cable can be adjusted based on personal preference. Before beginning the
adjustment, the Gas Spring Pin must be disengaged, and the Steering Module must be removed. Please refer to the Removal
of the Stering Module section and follow the procedure to Disconnect the Gas Spring Pin and Remove Motor from Mount. It is
important to remove the Gas Sping Pin and the Steering Module in order to access the Cable and associated hardware to make
any adjustments.
Adjusting the Pull Grip and Cable
WARNING
Please refer to the Removal of the Steering Module section of this manual and follow the procedure to Disconnect the Gas
Spring Pin and Remove Motor from Mount. It is important to remove the Steering Module and Remove the Gas Spring Pin
in order to access the Cable and associated hardware to make the adjustment. Failure to complete these necessary steps will
prevent the adjustment from being possible and will result in risk of injury.
NOTE:
Observe how the Cable is routed through
the Cable Guide, around the Pin, and into the Latch/
Strap Cable Pull Bracket.
b. Locate the end of the Cable and the Pull Cable
Clamp inside the Aluminum Arm of the Mount.
Rope Guide
Mount
Pin
Cable
Cable
Latch Strap Cable Pull Bracket
Pull Cable Clamp
1a
1b
