INSTALLING THE GAS SPRING PIN
j. Put a 1/4-20 x 3 1/2" Screw
(Item #4)
in each
of the drilled locations. The Screw should pass
through the Mount Plate and the boat deck.
k. Place a Flat Washer (Item #5) and then a Nylock
Nut (Item #6) at the end of each screw as shown
and secure. Make sure all hardware is secure.
5
ITEM(S) NEEDED
#4 x 6
#5 x 6
#6 x 6
NOTE:
To prevent seizing of the stainless steel
hardware, do not use high speed installation tools.
Wetting the screws or applying an anti-seize may
help prevent seizing.
Screw
Deck
Flat Washer and
Nylock Nut
Installing the Gas Spring Pin
1
a. Position the motor to the stowed position with
the Pull Grip and Cable to disengage the latch bar,
allowing the motor to fold into a flat position.
b. Once in the stowed or flat position, the Gas
Spring Pin and Spacers can be installed.
