minnkotamotors.com
12
Cancelling Rough Water Mode
Rough Water Mode can be cancelled two ways.
1.
Depress the
button, thereby turning off the RWM indicator
leD
. This will cancel the rough water mode.
2.
If the RWM is running a sequence, press the auto UP button
on the
control panel, or click the UP button
on the remote 1x. This will
cancel the RWM sequence, but the RWM indicator leD will remain on.
Deployment Notification Alarm
If installed, the auto alarm will emit a tone each time you turn the ignition key
to the on position if the anchor is not retracted. This alarm reminds you that
your Talon is still deployed. Taking off with the Talon in the deployed
position could cause damage to your anchor or boat which will not be covered
by warranty.
Retraction Notification Alarm
Your Talon is equipped with a built-in retraction control alarm to protect the lift
motor. If the lift capacity of the motor is exceeded -oR- the motor takes more
than 10 seconds to retract, the motor will stop and notify you with a series of
three triple beeps. (...-...-...)
The most common reasons for the Retraction notification alarm sounding are
1) because of an extremely soft or muddy bottom and the spike is deeply buried
and cannot retract on its own, or 2) there may be an excessive amount of side
load on the spike, generally due to fast moving water currents or wind.
minnkotamotors.com