minnkotamotors.com | 11
©2020 Johnson Outdoors Marine Electronics, Inc.
AUTOPILOT
CONTROLLING AUTOPILOT
Toggle AutoPilot On/Off
a. While the motor is running, AutoPilot can be turned
on by pressing the AutoPilot button located on
the Foot Pedal, CoPilot remote, or using either the
i-Pilot or i-Pilot Link remote.
NOTICE:
After steering to a new direction, there is a short
delay before the direction is locked in to allow the compass
to stabilize. When broad speed changes are made, the
AutoPilot heading may change slightly. This is normal.
When the AutoPilot is on and the trolling motor is pulled out of the water to the stow position, the steering motor will continue to run.
Turn off AutoPilot to stop the motor. If AutoPilot is left on, the steering motor will shut off automatically after 10 seconds. The motor
should not be stored in this condition for long periods as power is still being applied to all electronics. Always turn AutoPilot off and
disconnect your motor from the battery when storing your boat.
Possible Deviation
Possible Deviation
due to Wind/Current
due to Wind/Current
b. While AutoPilot is on, drive the boat as desired.
c. To turn AutoPilot off, press the AutoPilot button again.
CAUTION
When the AutoPilot is on and the trolling motor is pulled
out of the water to the stow position, the steering motor will
continue to run. Turn off the AutoPilot switch to stop the
motor. If the switch is left on, the steering motor will shut
off automatically after 10 seconds. The motor should not
be stored in this condition for long periods as power is still
being applied to all electronics. Always turn the Autopilot
switch off and disconnect your motor from the battery when
storing your boat.
AutoPilot
AutoPilot
Button
Button
Ulterra
Ulterra
Foot
Foot
Pedal
Pedal
This unit has an automatic steering shutdown for safety. In conditions where an obstruction prevents the trolling motor from turning, or
in extremely windy conditions, the automatic steering may stop. Any steering input will reset the system to normal.
When AutoPilot is "on" and the trolling motor is pulled out of the water to the stow position, the steering motor will continue to run
until the motor is stowed properly. Once the motor is stowed properly, AutoPilot will turn "off" and the AutoPilot Indicator will no longer
be illuminated.
AutoPilot
AutoPilot
Heading
Heading
1